enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. O-ring boss seal - Wikipedia

   en.wikipedia.org/wiki/O-ring_boss_seal

   An o-ring boss seal is a technique for joining two fluid-carrying pipes, hoses, or tubing. In an o-ring boss (abbreviated ORB) system, a male-threaded part is inserted into a female-threaded part, providing a mechanical seal. This system differs from others in that a nut is tightened over an o-ring in a chamfered area, creating a fluid-tight ...

3. O-ring - Wikipedia

   en.wikipedia.org/wiki/O-ring

   O-ring mounting for an ultra-high vacuum application. [11] Pressure distribution within the cross-section of the O-ring. The orange lines are hard surfaces, which apply high pressure. The fluid in the seams has lower pressure. The soft O-ring bridges the pressure over the seams. O-rings are available in various metric and inch standard sizes.

4. End-face mechanical seal - Wikipedia

   en.wikipedia.org/wiki/End-face_mechanical_seal

   There are a number of different ways in which “seals” may be classified. Sometimes a reference to a “seal” may be to a sealing system whereas other times the reference is to a device such as a gasket, an O-ring, compression packing, etc. In this article, the reference is to an end-face mechanical seal.

5. Hydraulic seal - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_seal

   Hydraulic Piston seals prevent fluid from crossing the area of the piston head. Rod seals ensure that fluid does not leak from the cylinder and adequate pressure is maintained. Wiper seals are installed to prevent contamination from entering the hydraulic system. [2] A rod seal prevents leakage of hydraulic fluid to the outside of the sealing ...

6. Back-up ring - Wikipedia

   en.wikipedia.org/wiki/Back-up_ring

   A back-up ring is a rigid ring that holds an elastomeric seal or plastic (such as Polyethylene) connection to its designed shape and in its correct place.Back up rings are commonly used with O-rings, lip seals, and as reciprocating shaft seals.

7. Cutting ring fitting - Wikipedia

   en.wikipedia.org/wiki/Cutting_ring_fitting

   They are used worldwide in hydraulic systems. The cutting ring fitting consists of the body, the cutting ring and the nut. On assembly, the two cutting edges of the cutting ring carves into the outer surface of the tube hence ensuring the necessary holding power and sealing for high operating pressures. [1] The tubes have usually metric dimensions.

8. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   The hydraulic diameter, D H, is a commonly used term when handling flow in non-circular tubes and channels. Using this term, one can calculate many things in the same way as for a round tube. Using this term, one can calculate many things in the same way as for a round tube.

9. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   the document number of the standard (e.g., ISO 7 or EN 10226) the symbol for the pipe thread type: G, external and internal parallel (ISO 228) R, external taper (ISO 7) Rp, internal parallel (ISO 7/1) Rc, internal taper (ISO 7) Rs, external parallel; the thread size; Threads are normally right-hand. For left-hand threads, the letters, LH, are ...