Ads
related to: carbide end mills feeds and speeds chart
Search results
Results from the WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
An end mill is a type of milling cutter, a cutting tool used in industrial milling applications. They can have several end configurations: round (ball), tapered, or straight are a few popular types. They are most commonly used in "milling machines" that move a piece of material against the end mill to remove chips of the material to create a ...
A machinist calculator is a hand-held calculator programmed with built-in formulas making it easy and quick for machinists to establish speeds, feeds and time without guesswork or conversion charts. Formulas may include revolutions per minute (RPM), surface feet per minute (SFM), inches per minute (IPM), feed per tooth (FPT). A cut time (CT ...
The speed at which the piece advances through the cutter is called feed rate, or just feed; it is most often measured as distance per time (inches per minute [in/min or ipm] or millimeters per minute [mm/min]), although distance per revolution or per cutter tooth are also sometimes used.
The words end mill are generally used to refer to flat bottomed cutters, but also include rounded cutters (referred to as ball nosed) and radiused cutters (referred to as bull nose, or torus). They are usually made from high speed steel or cemented carbide, and have one or more flutes. They are the most common tool used in a vertical mill.
It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall. If the value is larger than 1 it is called a trumpet. Depending on the material being cut, feed rate and other factors, a cutting tool with the optimum K factor should be used.
Ads
related to: carbide end mills feeds and speeds chart