enow.com Web Search

  1. Ads

    related to: blown fuel injection valve repair service prices near me

Search results

  1. Results from the WOW.Com Content Network
  2. Anti-dribble valve - Wikipedia

    en.wikipedia.org/wiki/Anti-dribble_valve

    These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...

  3. Marysville Auto Plant - Wikipedia

    en.wikipedia.org/wiki/Marysville_Auto_Plant

    Honda Marysville Auto Plant (MAP) is a Honda manufacturing facility located approximately six miles northwest of Marysville, Ohio, and 42 miles northwest of Columbus, Ohio, near the intersection of US 33 and State Route 739. It is one of the most integrated and flexible auto plants in North America.

  4. Drivers face costly repairs after diesel, unleaded fuel swap ...

    www.aol.com/drivers-face-costly-repairs-diesel...

    Diesel fuel was stored in an underground tank tied to an unleaded gasoline pump at a Circle K in Avon, Ohio, resulting in damages for 14 motorists. Drivers face costly repairs after diesel ...

  5. Fuel injection - Wikipedia

    en.wikipedia.org/wiki/Fuel_injection

    Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.

  6. Air-blast injection - Wikipedia

    en.wikipedia.org/wiki/Air-blast_injection

    A separate cam on the camshaft (as seen in Fig. 5 and on the two-cylinder Johann-Weitzer-engine on the right) would activate the injection valve so the compressed air would then press the fuel into the combustion chamber. Before the injection valve opens, neither fuel nor compressed air can enter the combustion chamber. [16]

  7. Electronically controlled unit injector - Wikipedia

    en.wikipedia.org/wiki/Electronically_controlled...

    Injection phase Partway through the pump stroke, the solenoid is energized, which closes the spill valve. The fuel is forced into the cylinder through the spray tip. Pressure reduction phase Toward the end of the pump stroke, the spill valve is re-opened, allowing the fuel to recirculate again and ending the injection phase.

  1. Ads

    related to: blown fuel injection valve repair service prices near me