Search results
Results from the WOW.Com Content Network
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The Roman foot (~296 mm) was divided into both 12 unciae (inches) (~24.7 mm) and 16 digits (~18.5 mm). The Romans also introduced the mille passus (1000 paces) or double steps, the pace being equal to five Roman feet (~1480 mm). The Roman mile of 5000 feet (1480 m) was introduced into England during the occupation.
One metre is exactly equivalent to 5 000 / 127 inches and to 1 250 / 1 143 yards. A simple mnemonic to assist with conversion is "three 3s": 1 metre is nearly equivalent to 3 feet 3 + 3 ⁄ 8 inches. This gives an overestimate of 0.125 mm. The ancient Egyptian cubit was about 0.5 m (surviving rods are 523–529 mm). [27]
They found that the underlying diameters of the stone circles had been consistently laid out using multiples of a base unit amounting to 30 long feet, which they calculated to be 1.056 of a modern international foot (thus 12.672 inches or 0.3219 m).
Following the so-called "quarter-girth formula" (the square of one quarter of the circumference in inches multiplied by 1 ⁄ 144 of the length in feet), the notional log is four feet in circumference, one inch of which yields the hoppus board foot, 1 foot yields the hoppus foot, and 50 feet yields a hoppus ton.