Search results
Results from the WOW.Com Content Network
Creep and shrinkage can cause a major loss of prestress. Underestimation of multi-decade creep has caused excessive deflections, often with cracking, in many of large-span prestressed segmentally erected box girder bridges (over 60 cases documented). Creep may cause excessive stress and cracking in cable-stayed or arch bridges, and roof shells ...
The phenomenological equation which describes Harper–Dorn creep is = where ρ 0 is dislocation density (constant for Harper–Dorn creep), D v is the diffusivity through the volume of the material, G is the shear modulus and b is the Burgers vector, σ s, and n is the stress exponent which varies between 1 and 3.
The first constitutive equation (constitutive law) was developed by Robert Hooke and is known as Hooke's law.It deals with the case of linear elastic materials.Following this discovery, this type of equation, often called a "stress-strain relation" in this example, but also called a "constitutive assumption" or an "equation of state" was commonly used.
L. M. Kachanov [5] and Y. N. Rabotnov [6] suggested the following evolution equations for the creep strain ε and a lumped damage state variable ω: ˙ = ˙ ˙ = ˙ where ˙ is the creep strain rate, ˙ is the creep-rate multiplier, is the applied stress, is the creep stress exponent of the material of interest, ˙ is the rate of damage accumulation, ˙ is the damage-rate multiplier, and is ...
Stress Intensity Equation. As the fibrils in the crack begin to rupture the crack will advance in either a stable, unstable or critical growth depending on the toughness of the material. To accurately determine the stability of a crack growth and R curve plot should be constructed. A unique tip of fracture mode is called stick/slip crack growth.
Nabbaro–Herring creep does not involve the motion of dislocations. It predominates over high-temperature dislocation-dependent mechanisms only at low stresses, and then only for fine-grained materials. Nabarro–Herring creep is characterized by creep rates that increase linearly with the stress and inversely with the square of grain diameter.
In materials science, Coble creep, a form of diffusion creep, is a mechanism for deformation of crystalline solids. Contrasted with other diffusional creep mechanisms, Coble creep is similar to Nabarro–Herring creep in that it is dominant at lower stress levels and higher temperatures than creep mechanisms utilizing dislocation glide. [1]
Primary Creep: the initial creep stage where the slope is rising rapidly at first in a short amount of time. After a certain amount of time has elapsed, the slope will begin to slowly decrease from its initial rise. Steady State Creep: the creep rate is constant so the line on the curve shows a straight line that is a steady rate.