Search results
Results from the WOW.Com Content Network
Installed laminate floors typically "float" over the sub-floor on top of a foam/film underlayment, which provides moisture- and sound-reducing properties. A small (1–10 mm [1 ⁄ 16 – 3 ⁄ 8 in]) gap is required between the flooring and any immovable object such as walls, this allows the flooring to expand without being obstructed.
Laminate panels are used instead of plywood because of their resistance to impact, weather, moisture, shattering in cold (ductility), and chemicals. Laminate panel layers (called veneers) are glued together with adjacent plies having their grain at right angles to each other for greater strength. The plastic layer(s) added for protection vary ...
Underlay is also the term for the material under roofing tiles; [1] this roofing membrane is often made of rubber and is used to seal the roof and prevent leakage. Underlayment used with roofing shingles provides a second layer of water proofing to prevent leaks and is called tar paper, roofing felt, or since the 1990s synthetic underlayment ...
Initially modern dropped ceilings were built using interlocking tiles and the only way to provide access for repair or inspection of the area above the tiles was by starting at the edge of the ceiling, or at a designated "key tile", and then removing contiguous tiles one at a time until the desired place of access was reached.
Ceramic tiles are clay products that are formed into thin tiles and fired. Ceramic tiles are set in beds of mortar or mastic with the joints between tiles grouted. Varieties of ceramic tiles include quarry tile, porcelain, and terracotta. Many different natural stones are cut into a variety of sizes, shapes, and thicknesses for use as flooring.
Decorative laminate Roll and sheet of decorative laminate. Decorative laminates are laminated products primarily used as furniture surface materials or wall paneling.It can be manufactured as either high- or low-pressure laminate, with the two processes not much different from each other except for the pressure applied in the pressing process.
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...