enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

3. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

5. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Pipe coupling (copper sweat) In piping and plumbing , a coupling (or coupler ) is a very short length of pipe or tube , with a socket at one or both ends that allows two pipes or tubes to be joined, welded ( steel ), brazed or soldered ( copper , brass etc.) together.

6. Solder ring fitting - Wikipedia

   en.wikipedia.org/wiki/Solder_ring_fitting

   The fittings come in a variety of configurations, such as tee-pieces, straight couplers, elbows or bends, reducers (to join pipes of different diameters), stop-ends, and there are versions with screw threads (male or female) at one end to fit taps and iron pipes. Valves such as stoptaps & gate valves are also available in solder ring configuration.

7. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Copper and its alloys, mild steel, and in some cases small diameter stainless steel pipes are most commonly reamed with hand tools. [ 15 ] Copper is perfectly machinable, a quality tool successfully performs wall deformation, the surface remains smooth, the wall thickness is almost the same, and the material retains a homogeneous structure.