enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micro ribbon connector - Wikipedia

   en.wikipedia.org/wiki/Micro_ribbon_connector

   Other connectors of this size are also called Centronics connectors. The smaller size has 0.050 inch (1.27 mm) pitch. This size, with 36 pins, is also known as a mini-Centronics connector, and is standardized as IEEE 1284 type C.

3. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   These connectors had the same number of pins as the above DE-15 connectors, but used the more traditional pin size, pin spacing, and size shell of the DA-15 standard connector. "VGA adapters" (i.e. DA-15 to DE-15 dongles) were available but sometimes monitor-specific, or they needed DIP switch configuration, as the Macintosh's monitor sense ...

4. Parallel port - Wikipedia

   en.wikipedia.org/wiki/Parallel_port

   Mini-Centronics 36-pin male connector (top) with Micro ribbon 36-pin male Centronics connector (bottom) The Apple II Parallel Printer Port connected to the printer via a folded ribbon cable; one end connected to the connector at the top of the card, and the other end had a 36-pin Centronics connector.

5. RS-232 - Wikipedia

   en.wikipedia.org/wiki/RS-232

   A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.

6. IEEE 1284 - Wikipedia

   en.wikipedia.org/wiki/IEEE_1284

   An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.

7. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart. This connector has no retaining screws to secure the connectors together, and ribbon cables are both inconveniently wide and somewhat delicate, so this connector style was ...