Search results
Results from the WOW.Com Content Network
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
The main disadvantage is that belts wear over time, therefore belt replacement is recommended at specific intervals. [5] [6] Replacement of the engine's water pump at the same time is often recommended, since the water pump is also subject to wear and easily accessed during the replacement of the timing belt.
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
Toothed belts are used widely in mechanical devices, including sewing machines, photocopiers and many others. A major use of toothed belts is as the timing belt used to drive the camshafts within an automobile or motorcycle engine. As toothed belts can deliver more power than a friction-drive belt, they are used for high-power transmissions.
A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain. The earliest evidence of pulleys dates back to Ancient Egypt in the Twelfth Dynasty (1991–1802 BC) [1] and Mesopotamia in the early 2nd millennium BC. [2]
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
The belt sway switch will stop the conveyor if the belt starts losing its alignment along the structure. The speed switch will stop the belt if the switch is not registering that the belt is running at the required speed. The belt rip switch will stop the belt when there is a cut, or a flap indicating that the belt is in danger of further damage.
Chain Belt Company was an agricultural equipment manufacturer in the US. It produced chain belts specifically to replace leather-based belts, which were used inside ...