Search results
Results from the WOW.Com Content Network
Normal contact mechanics or frictionless contact mechanics focuses on normal stresses caused by applied normal forces and by the adhesion present on surfaces in close contact, even if they are clean and dry. Frictional contact mechanics emphasizes the effect of friction forces. Contact mechanics is part of mechanical engineering.
Illustration of tangential and normal components of a vector to a surface. In mathematics, given a vector at a point on a curve, that vector can be decomposed uniquely as a sum of two vectors, one tangent to the curve, called the tangential component of the vector, and another one perpendicular to the curve, called the normal component of the vector.
The normal force can point downwards. The normal force can point downwards. Considering that the object is a person sitting inside a plane moving in a circle, the two forces (weight and normal force) will point down only when the plane reaches the top of the circle. The reason for this is that the normal force is the sum of the tangential force ...
But if the normal stress in the contact interface induces the same tangential displacements in both contacting bodies, then there is no relative tangential displacement of the two surfaces. In that case, the normal and tangential contact problems are decoupled. If this is the case then the two bodies are called quasi-identical. This happens for ...
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
For the thin-walled assumption to be valid, the vessel must have a wall thickness of no more than about one-tenth (often cited as Diameter / t > 20) of its radius. [4] This allows for treating the wall as a surface, and subsequently using the Young–Laplace equation for estimating the hoop stress created by an internal pressure on a thin-walled cylindrical pressure vessel:
With cylindrical co-ordinates which are described as î and j, the motion is best described in polar form with components that resemble polar vectors.As with planar motion, the velocity is always tangential to the curve, but in this form acceleration consist of different intermediate components that can now run along the radius and its normal vector.
Figure 2: Weight (W), the frictional force (F r), and the normal force (F n) acting on a block.Weight is the product of mass (m) and the acceleration of gravity (g).In the case of an object resting upon a flat table (unlike on an incline as in Figures 1 and 2), the normal force on the object is equal but in opposite direction to the gravitational force applied on the object (or the weight of ...