Search results
Results from the WOW.Com Content Network
In business telephony, a telephone extension may refer to a phone on an internal telephone line attached to a private branch exchange (PBX) or Centrex system. The PBX operates much as a community switchboard does for a geographic telephone numbering plan and allows multiple lines inside the office to connect without each phone requiring a ...
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
Typically it will have a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the line, unlike RJ11, which uses pins 3 and 4).
600 series connectors. A 600 series connector is an obsolete three-pin connector with up to six conductors.. It was for many years the standard telephone service connector in Australia, used on rural party lines and the national Postmaster-General's Department (later Telstra) landline network, but has since the 1970s been superseded by the six position modular connector in this application.
TAE socket. A typical TAE installation is a multi-socket junction box with at least one N connector and one F connector socket in the box, but having usually two N and one F connector. Up to three N connectors are possible. Network service enters the box and connects to pins 1 and 2 on the right-most N connector.
Neither plug nor socket is compatible with other plugs and sockets. It is defined in Swedish Standard SS 455 15 50. Swedish telephone socket of older design. The four angled slots are the connectors while the bigger slot in the lower middle is the presence slot. Above it is a screw. The embossed text underneath the circular indention reads ...
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
The outside line is connected to the line connector, and handsets may be connected to the phone connector. When the modem is not in use, the line is connected to the handsets, but when the modem is in use, the phone connector is disconnected from the outside line. This prevents accidental interruption of the data service by raising the handset ...