enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Side and end view of a 4-fluted countersink. The fluted countersink cutter is used to provide a heavy chamfer in the entrance to a drilled hole. This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping. Countersink cutters are manufactured with six ...

3. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   A counterbore in a metal plate. In machining, a counterbore (symbol: ⌴) is a cylindrical flat-bottomed hole that enlarges another coaxial hole, or the tool used to create that feature. A counterbore hole is typically used when a fastener, such as a socket head cap screw or fillister head screw, is required to sit flush with or below the level ...

4. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth. British Standard Whitworth (BSW) is an imperial-unit -based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper.

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   Drill bit. From top: Spade, brad point, masonry, and twist drills bits. Drill bit (upper left), mounted on a pistol-grip electric drill. A set of masonry drills. A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create ...

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   List of screw drives. At a minimum, a screw drive is a set of shaped cavities and protrusions on the screw head that allows torque to be applied to it. [1][2] Usually, it also involves a mating tool, such as a screwdriver, that is used to turn it. Some of the less-common drives are classified as being "tamper-resistant".

7. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   A cap screw with a socket head (usually implying a hex socket, driven with a hex key. SHN: shown: See Part number > Symmetrical parts for explanation. SHSS: socket head set screw: A set screw with a socket head (usually implying a hex socket, driven with a hex key. SI: Système international [d'unités] [International System of Units]