Search results
Results from the WOW.Com Content Network
The aileron roll is commonly executed through the application of full aileron in one direction. In some lower powered general aviation and aerobatic training aircraft, prior to applying aileron input, the pilot must begin the maneuver by trading altitude for airspeed (i.e. diving).
Aileron roll; 360° revolution about the longitudinal axis at maximum roll rate. It consists of a pitch-up followed by a roll which is uncontrolled in the pitch axis, resulting in an initial climb, and then descent to the original altitude. Slow roll; roll around the longitudinal axis slowly, maintaining level flight by cross-controlling the ...
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
A control system includes control surfaces which, when deflected, generate a moment (or couple from ailerons) about the cg which rotates the aircraft in pitch, roll, and yaw. For example, a pitching moment comes from a force applied at a distance forward or aft of the cg, causing the aircraft to pitch up or down.
An aircraft 'rolling', or 'banking', with its ailerons An aileron and roll trim tab of a light aircraft An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft . [ 1 ]
The snap roll is an aggressive roll. The aircraft rotates about all axes at the same time, the predominant rotation being about the longitudinal axis. This sometimes violent maneuver is accomplished one of two ways. A positive, or inside, snap is executed by going hard over on all controls: full aileron, full rudder, and full up elevator.
To successfully execute a roll-off-the-top turn, the pilot accelerates to sufficient airspeed to perform a loop in the aircraft. The pilot then pulls the aircraft into a climb, and continues to pull back on the controls as the aircraft climbs. Rudder and ailerons must be used to keep the half-loop straight when viewed from the ground.
This is typically controlled by the rudder at the rear of the airplane. Roll (bank) – in which one wing of the airplane moves up and the other moves down. This is typically controlled by ailerons on the wings of the airplane. Coordinated flight requires the pilot to use pitch, roll and yaw control simultaneously. See also flight dynamics.