enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Auxiliary hydraulic system - Wikipedia

   en.wikipedia.org/wiki/Auxiliary_hydraulic_system

   Vehicle interface fittings, length from pump to attachment and vehicle control systems require various configurations of an auxiliary hydraulic system. Auxiliary hydraulic systems usually include external fluid fittings to facilitate connecting and disconnecting the hydraulic fluid supply lines of the attachments to the vehicles' hydraulic pump ...

3. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose. The AN thread (also A-N) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

4. Braided stainless steel brake lines - Wikipedia

   en.wikipedia.org/wiki/Braided_stainless_steel...

   Braided stainless steel brake lines (also known as braided stainless steel brake hoses) are flexible hoses fitted to a hydraulic brake system. The intent of braided stainless steel brake lines is to improve brake system effectiveness and longevity as compared to an equivalent system fitted with flexible rubber hoses through near-elimination of hose expansion.

5. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

6. Banjo fitting - Wikipedia

   en.wikipedia.org/wiki/Banjo_fitting

   The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids damage that can be caused by twisting the hose during installation.

7. Engineering drawing - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing

   Type F lines are Type E lines, except these are used for drawings in electrotechnology. 2H pencil; Type G lines are used for centre lines. These are dotted lines, but a long line of 10–20 mm, then a 1 mm gap, then a small line of 2 mm. 2H pencil; Type H lines are the same as type G, except that every second long line is thicker. These ...