Search results
Results from the WOW.Com Content Network
Ammonium chloride is an inorganic chemical compound with the chemical formula N H 4 Cl, also written as [NH 4]Cl. It is an ammonium salt of hydrogen chloride. It consists of ammonium cations [NH 4] + and chloride anions Cl −. It is a white crystalline salt that is highly soluble in water. Solutions of ammonium chloride are mildly acidic.
Hence, the pK of each buffer will dictate the ratio of the concentrations of its base and weak acid forms at the given pH, in accordance with the Henderson-Hasselbalch equation. Any condition that changes the balance of one of the buffer systems, also changes the balance of all the others because the buffer systems actually buffer one another ...
Buffer capacity falls to 33% of the maximum value at pH = pK a ± 1, to 10% at pH = pK a ± 1.5 and to 1% at pH = pK a ± 2. For this reason the most useful range is approximately p K a ± 1. When choosing a buffer for use at a specific pH, it should have a p K a value as close as possible to that pH.
In aqueous solution, ammonia deprotonates a small fraction of the water to give ammonium and hydroxide according to the following equilibrium: . NH 3 + H 2 O ⇌ NH + 4 + OH −.. In a 1 M ammonia solution, about 0.42% of the ammonia is converted to ammonium, equivalent to pH = 11.63 because [NH +
If the pH is known, the ratio may be calculated. This ratio is independent of the analytical concentration of the acid. In water, measurable pK a values range from about −2 for a strong acid to about 12 for a very weak acid (or strong base). A buffer solution of a desired pH can be prepared as a mixture of a weak acid and its conjugate base ...
The Henderson–Hasselbalch equation can be used to estimate the pH of a buffer solution by approximating the actual concentration ratio as the ratio of the analytical concentrations of the acid and of a salt, MA. The equation can also be applied to bases by specifying the protonated form of the base as the acid.
Charge balance is used in the fourth equation, where the left hand side represents the total charge of the cations and the right hand side represents the total charge of the anions: is the molarity of the cation (e.g. sodium, if sodium salt of the acid or sodium hydroxide is used in making the buffer).
The equation can only be applied when the purged volume of vapor or gas is replaced with "clean" air or gas. For example, the equation can be used to calculate the time required at a certain ventilation rate to reduce a high carbon monoxide concentration in a room.