Search results
Results from the WOW.Com Content Network
A flaperon (a portmanteau of flap and aileron) on an aircraft's wing is a type of control surface that combines the functions of both flaps and ailerons. Some smaller kitplanes have flaperons for reasons of simplicity of manufacture, while some large commercial aircraft such as the Boeing 747 , 767 , 777 , and 787 may have a flaperon between ...
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
Trailing edge flaps extended on the right on a typical airliner (an Airbus A310-300). Leading edge slats are also extended, on the left. A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the ...
Another aircraft with full-length double-slotted flaps was the Wren 460. To go with large aileron deflections at low speeds [5] it had a set of five feathering drag plates ahead of each aileron to overcome adverse aileron yaw and decrease lift on the low wing. [6] Boeing's line of jet airliners have flight spoilers which can act as roll ...
Flap – is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the take-off distance and the landing distance. Flaps also cause an increase in drag so they are retracted when not needed.
X-53 Active Aeroelastic Wing in flight. Several technology research and development efforts exist to integrate the functions of aircraft flight control systems such as ailerons, elevators, elevons and flaps into wings to perform the aerodynamic purpose with the advantages of less: mass, cost, drag, inertia (for faster, stronger control response), complexity (mechanically simpler, fewer moving ...
An aircraft 'rolling', or 'banking', with its ailerons An aileron and roll trim tab of a light aircraft An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft . [ 1 ]
The triple-slotted trailing edge flaps are well displayed and the Krueger flaps on the leading edge also are visible. In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable ...