Search results
Results from the WOW.Com Content Network
For a given sail area a gaff rig has a shorter mast than a Bermudan rig.In short-ended craft with full body, heavy displacement and moderate ballast ratio, it is difficult to set enough sail area in the Bermudan rig without a mast of excessive height and a centre of effort (CE) too high for the limited stability of the hull. [8]
Anchor: a device for holding a boat to the seabed, typically with chain and rope. Traditional anchors include the fisherman, Danforth, and plough types (such as the "CQR" and "Delta"). Recently, far more effective anchors with more reliable holding include the "Rocna" and the "Ultra", both of which are spade anchors.
Schematic cross section of a pressurized caisson. In geotechnical engineering, a caisson (/ ˈ k eɪ s ən,-s ɒ n /; borrowed from French caisson 'box', from Italian cassone 'large box', an augmentative of cassa) is a watertight retaining structure [1] used, for example, to work on the foundations of a bridge pier, for the construction of a concrete dam, [2] or for the repair of ships.
Fore-and-aft rigged sails include staysails, Bermuda rigged sails, gaff rigged sails, gaff sails, gunter rig, lateen sails, lug sails, tanja sails, the spanker sail on a square rig, and crab claw sails. Fore-and-aft rigs include: Rigs with one mast: the proa, the catboat, the sloop, the cutter; Rigs with two masts: the ketch, the yawl
Bitts are paired vertical wooden or metal posts mounted either aboard a ship or on a wharf, pier, or quay. The posts are used to secure mooring lines, ropes, hawsers, or cables. [1] Bitts aboard wooden sailing ships (sometime called cable-bitts) were large vertical timbers mortised into the keel and used as the anchor cable attachment point. [2]
On modern yachts, standing rigging is often stainless steel wire, Nitronic-50 stainless steel rod or synthetic fiber.Semi-rigid stainless steel wire is by far the most common as it combines extreme strength, relative ease of assembling and rigging with reliability.
This type consists of a rod with wide screw blades on the end and an eyelet on the other for the guy wire. It is screwed deep into the ground, at the same angle as the guy, by a truck-mounted drill machine. These are commonly used as guy anchors for utility poles since they are quick to install with a truck mounted hydraulic powered auger drive.
A cam cleat in which one or two spring-loaded cams pinch the rope, allowing the rope to be adjusted easily, and quickly released when under load. A jam cleat in which the line is pinched in a v-shaped slot. A clam cleat (or jam cleat) in which the rope is held between two fluted stationary pieces. Such a cleat vaguely resembles two halves of a ...