Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
Old Macintosh DB-25 SCSI port (narrow) Apple used DB-25 connectors, which, having only 25 pins rather than 50, were smaller and less expensive to make, but decreased signal integrity (increasing crosstalk) [citation needed] and cannot be used with differential signaling. Furthermore, DB-25s were commonly used for RS-232 serial cables and also ...
When IBM implemented the parallel interface on the IBM PC, they used the DB-25F connector at the PC-end of the interface, creating the now familiar parallel cable with a DB25M at one end and a 36-pin micro ribbon connector at the other. In theory, the Centronics port could transfer data as rapidly as 75,000 characters per second.
Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...
Because personal computers first used DB-25 connectors for their serial and parallel ports, when the PC serial port began to use 9-pin connectors, they were often labeled as DB-9 instead of DE-9 connectors, due to an ignorance of the fact that B represented a shell size. It is now common to see DE-9 connectors sold as DB-9 connectors.
Generally, serial port connectors are gendered, only allowing connectors to mate with a connector of the opposite gender. With D-subminiature connectors, the male connectors have protruding pins, and female connectors have corresponding round sockets. [2] Either type of connector can be mounted on equipment or a panel; or terminate a cable.
SASI, which was used in mini- and early microcomputers, defined the interface as using a 50-pin flat ribbon connector which was adopted as the SCSI-1 connector. SASI is a fully compliant subset of SCSI-1 so that many, if not all, of the then-existing SASI controllers were SCSI-1 compatible.
A diagram of the DB-25 connector. Date: 18 June 2006 (original upload date) Source: No machine-readable source provided. Own work assumed (based on copyright claims). Author: No machine-readable author provided. Mobius assumed (based on copyright claims). Other versions