Search results
Results from the WOW.Com Content Network
The 201A Data-Phone was a synchronous modem using two-bit-per-symbol phase-shift keying (PSK) encoding, achieving 2,000 bit/s half-duplex over normal phone lines. [10] In this system the two tones for any one side of the connection are sent at similar frequencies as in the 300 bit/s systems, but slightly out of phase.
DSL uses these higher frequencies to send digital data between the DSL modem and the local switching center, without interfering with normal telephone service. At the local switching center the data is transferred directly between the customer's phone line and internet lines, so DSL signals do not travel through the telephone network itself.
A modem flap is when the connection by the modem to the head-end has been dropped (gone offline) and then comes back online. The time offline or rate of flap is not typically recorded, only the incidence. While this is a common occurrence and usually unnoticed, if a modem's flap is extremely high, these disconnects can cause service to be ...
An Internet-accessing smartphone may have the same capabilities as a standalone modem, and, when connected via a USB cable to a computer, can serve as a modem for the computer. Smartphones with built-in Wi-Fi also typically provide routing and wireless access point facilities. This method of connecting is commonly referred to as "tethering." [9]
The Bell 212A scheme was the most common standard used for 1200 bit/s transmission on US data networks such as CompuServe during the 1980s and 1990s, when dial-up access to time-sharing services was the norm, and, starting in 1989, dial-up Internet access.
The modem uses the Data Carrier Detect (DCD) pin to signal whether it's connected to a host. The computer can generally just read the DCD pin at any time and always know if the modem is in command or data mode. DCD high means data mode, and low means command mode. DCD is a signal sent from the modem to the computer.
A cable modem termination system (CMTS, also called a CMTS Edge Router) [1] is a piece of equipment, typically located in a cable company's headend or hubsite, which is used to provide data services, such as cable Internet or Voice over IP, to cable subscribers.
In telecommunications, broadband or high speed is the wide-bandwidth data transmission that exploits signals at a wide spread of frequencies or several different simultaneous frequencies, and is used in fast Internet access. The transmission medium can be coaxial cable, optical fiber, wireless Internet , twisted pair cable, or satellite.