Search results
Results from the WOW.Com Content Network
Except Wairarapa Line beyond Upper Hutt. Since 2011, the nominal voltage was 1600 V but with the same tolerances as 1500 V (i.e. 1300–1800 V), making it backwards-compatible with 1500 V rolling stock. Since May 2016 the operating voltage was increased to 1700 V DC following the full introduction of the Matangi EMUs. Philippines: Metro Manila
A single-phase, three-winding converter transformer. The converter transformers step up the voltage of the AC supply network. Using a star-to-delta or "wye-delta" connection of the transformer windings, the converter can operate with 12 pulses for each cycle in the AC supply, which eliminates numerous harmonic current components. The insulation ...
These systems can be used to convert three-phase 50 Hz or 60 Hz alternating current (AC) for the supply of AC railway electrification systems at a lower frequency and single phase, as used by many older systems, or to rectify AC into direct current (DC) for those systems (primarily public transit systems) using DC for traction power.
Halogen lamp (105 W) for replacement purposes with an E27 screw base A close-up of a halogen lamp capsule A halogen lamp (also called tungsten halogen , quartz-halogen , and quartz iodine lamp) is an incandescent lamp consisting of a tungsten filament sealed in a compact transparent envelope that is filled with a mixture of an inert gas and a ...
A transformer supplying a three-wire distribution system has a single-phase input (primary) winding. The output (secondary) winding has a center tap connected to a grounded neutral. As shown in Fig. 1, either end to center has half the voltage of end-to-end. Fig. 2 illustrates the phasor diagram
The secondary winding of the local transformer will supply the customer with either single ended single phase (N-0) or split-phase (N-0-N) power in the region's standard appliance voltages, with the 0 volt line connected to a safety earth that does not normally carry an operating current.
A common source of unintentional backfeeding is an electrical generator (typically a portable generator) that is improperly connected to a building electrical system.A properly installed electrical generator incorporates the use of a transfer switch or generator interlock kit to ensure the incoming electrical service line is disconnected when the generator is providing power to the building.
Control of solid state loads with transformer isolation: 60947-5-1 AC-14: Control of small electromagnetic loads: 60947-5-1 AC-15: Control of A.C. electromagnetic loads: 60947-5-1 AC-20: Connecting and disconnecting under no-load conditions: 60947-3 AC-21: Switching of resistive loads, including moderate overloads: 60947-3 AC-22