Search results
Results from the WOW.Com Content Network
A test tube holder is used to hold test tubes. [1] It is used for holding a test tube in place [2] when the tube is hot or should not be touched. [3] For example, a test tube holder can be used to hold a test tube while it is being heated. [4]
The tube is usually held by its neck with a clamp or tongs. By tilting the tube, the bottom can be heated to hundreds of degrees in the flame, while the neck remains relatively cool, possibly allowing vapours to condense on its walls. A boiling tube is a large test tube intended specifically for boiling liquids.
Test Tube Rack. Test tube racks are laboratory equipment used to hold upright multiple test tubes at the same time. They are most commonly used when various different solutions are needed to work with simultaneously, for safety reasons, for safe storage of test tubes, and to ease the transport of multiple tubes.
(A) A low-form or Griffin form beaker (B) A tall-form or Berzelius beaker (C) A flat beaker or crystallizer Philips beaker which can be swirled like a conical flask. Standard or "low-form" (A) beakers typically have a height about 1.4 times the diameter. [3]
Test tube: Folin-Wu tube: Glass slide mycole and cover slips: in microscopy, serology, etc. as the solid backing on which test samples are Petri dish: used for preparation of culture media and the culture of organisms they are in Glass beaker: reagent storage Glass flask: gastric acid, or other fluid titration: Pasteur pipette
These tubes are usually made of glass, but can also be made of plastic or metal. They vary in size and purpose. Laboratory sample tubes must not be confused with glass tubing, which can be utilized to carry fluid between laboratory equipment. Example laboratory sample tubes are listed below: Ignition tube; Test tube; Boiling tube; NMR tube
A shaker is a piece of laboratory equipment used to mix, blend, or agitate substances in a tube or flask by shaking them. It is mainly used in the fields of chemistry and biology . A shaker contains an oscillating board that is used to place the flasks, beakers , or test tubes.
A Craig tube consists of two parts. The first is a stout-walled test tube with a working volume of about 1-5 ml (say, 7-8 cm in length and 1-1.5 cm in diameter). There is a constriction towards the open end of the tube.