Search results
Results from the WOW.Com Content Network
The reason for the clockwise standard for most screws and bolts is that supination of the arm, which is used by a right-handed person to tighten a screw clockwise, is generally stronger than pronation used to loosen. Sometimes the opposite (left-handed, counterclockwise, reverse) sense of threading is used for a special reason.
represents a counterclockwise rotation of a vector v by an angle θ, or a rotation of CS by the same angle but in the opposite direction (i.e. clockwise). Alibi and alias transformations are also known as active and passive transformations, respectively.
In the new coordinate system, the point P will appear to have been rotated in the opposite direction, that is, clockwise through the angle . A rotation of axes in more than two dimensions is defined similarly. [2] [3] A rotation of axes is a linear map [4] [5] and a rigid transformation.
When graphing visual binaries, the NCP is, as in the illustration, normally drawn from the center point (origin) that is the Primary downward–that is, with north at bottom–and PA is measured counterclockwise. Also, the direction of the proper motion can, for example, be given by its position angle.
The counterclockwise-rotating vector (cos t, sin t) has a positive frequency of +1 radian per unit of time.Not shown is a clockwise-rotating vector (cos (−t), sin (−t)) which has a negative frequency of -1 radian per unit of time.
The calculation is essentially the conversion of the equatorial polar coordinates of Mecca (i.e. its longitude and latitude) to its polar coordinates (i.e. its qibla and distance) relative to a system whose reference meridian is the great circle through the given location and the Earth's poles and whose polar axis is the line through the ...
The first two columns give the number of points and degrees clockwise from north. The third gives the equivalent bearing to the nearest degree from north or south towards east or west. The "CW" column gives the fractional-point bearings increasing in the clockwise direction and "CCW" counterclockwise. The final three columns show three common ...
If the determinant is negative, then the polygon is oriented clockwise. If the determinant is positive, the polygon is oriented counterclockwise. The determinant is non-zero if points A, B, and C are non-collinear. In the above example, with points ordered A, B, C, etc., the determinant is negative, and therefore the polygon is clockwise.