Search results
Results from the WOW.Com Content Network
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
It allows a V6 or V8 engine to "turn off" half of the cylinders under light-load conditions to improve fuel economy. Estimated performance on EPA tests shows a 5.5–7.5% improvement in fuel economy. [1] GM's Active Fuel Management [2] technology used a solenoid to deactivate the lifters on selected cylinders of a pushrod V-layout engine.
The Duramax V8 engine is a family of 6.6-liter diesel V8 engines produced by DMAX, a wholly owned subsidiary of General Motors in Moraine, Ohio.The Duramax block and heads are supplied from reliable vendors of General Motors.
GM's German subsidiary, Opel, relies on a range of three-, four- and six-cylinder gasoline and diesel engines. A survey [citation needed] of their range shows a reliance on petrol and diesel four-cylinders, and in 2014, there was only one 3-cylinder engine and one 6 cylinder engine in service in Opel's passenger car range.
GMC's own V8 was the 637-cubic-inch (10.4 L) unit, which was essentially a 478 V6 with two cylinders added. It shared the 5.125 in × 3.86 in (130.2 mm × 98.0 mm) bore and stroke and used a single camshaft. It was manufactured in gasoline and diesel versions, and was the largest-displacement production gasoline V8 ever made for highway trucks.
The GMC V6 is a family of 60-degree V6 engines produced by the GMC division of General Motors from 1959 through 1974. It was developed into both gasoline and diesel versions, and produced in V8 and V12 derivatives. Examples of this engine family were found in pickup trucks, Suburbans, heavier trucks, and motor coaches.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in³ (1980-1983).
The GMC straight-6 engine was a series of gasoline-powered straight-six engines introduced in the 1939 model year by the GMC Trucks division of General Motors. Prior to the introduction of this new engine design GMC trucks had been powered by straight-six engines designed by the Buick , Pontiac and Oldsmobile divisions of GM.