enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Anchor bolts are used to connect structural and non-structural elements to concrete. [2] The connection can be made by a variety of different components: anchor bolts (also named fasteners), steel plates, or stiffeners. Anchor bolts transfer different types of load: tension forces and shear forces. [3]

3. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...

4. Tackle DIY Projects With 41% Off This Craftsman 230-Piece ...

   www.aol.com/tackle-diy-projects-41-off-153400902...

   You can now get this Craftsman 230-Piece Standard (SAE) and Metric Mechanics Tool Set for 41 percent off at Lowe’s. You can pick one up to celebrate the start of summer or as a last-minute ...

5. Anchor channel - Wikipedia

   en.wikipedia.org/wiki/Anchor_channel

   Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.

6. 3 Best Christmas Items at Lowe’s That Can Be Reused ... - AOL

   www.aol.com/3-best-christmas-items-lowe...

   These standout items from Lowe’s collection of well-designed, high-quality decorations are worth considering.” Check Out: 8 Christmas Items To Get at Five Below That Cost Way More at Walmart

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...