enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   A "speed base" makes use of a base "cap moulding" set on top of a plain 1" thick board, however there are hundreds of baseboard profiles. Baton: See Torus; Batten or board and batten: Symmetrical moulding that is placed across a joint where two parallel panels or boards meet; Bead moulding: Narrow, half-round convex moulding, when repeated ...

3. Baseboard - Wikipedia

   en.wikipedia.org/wiki/Baseboard

   A baseboard differs from a wainscot; a wainscot typically covers from the floor to around 1-1.5 metres (3' to 5') high (waist or chest height), whereas a baseboard is typically under 0.2 metres (8") high (ankle height). Plastic baseboard comes in various plastic compounds, the most common of which is UPVC.

4. Quarter round - Wikipedia

   en.wikipedia.org/wiki/Quarter_round

   Quarter round molding at the edge of a parquet floor. A quarter round is a convex molding whose cross section is a quarter circle. It is one form of ovolo. A variation is a base shoe, a quarter of an ellipse. [1] Most quarter round is of small gauge and relatively flexible.

5. Ovolo - Wikipedia

   en.wikipedia.org/wiki/Ovolo

   The quarter-round cross-sectional profile of the fundamental design element, the ovolo, in an unadorned molding, showing also with its resulting shadow pattern. Ovolo is an Italian word that means "little egg" [1].The ovolo or echinus is a convex decorative molding profile used in architectural ornamentation. Its profile is a quarter to a half ...

6. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.

7. Cube mold technology - Wikipedia

   en.wikipedia.org/wiki/Cube_mold_technology

   The lower section of the mold runs on the machine base and the lower machine tie bars. The top section of the part runs on the upper machine tie bars. In this technology, components are molded within the rotating system at different steps. Below are the different steps-[4] The initial moldings are performed in a cavity of the first parting line.