enow.com Web Search

  1. Ads

    related to: post to deck connection detail design and layout

Search results

  1. Results from the WOW.Com Content Network
  2. Deck railing - Wikipedia

    en.wikipedia.org/wiki/Deck_railing

    In between the posts, two 2x4s are attached to the posts with screws for the best connection. The lower board is placed 3.5" from the top of the finish deck to the bottom of the board. The top board is placed with the top at 35" from the deck. Then the vertical 2x2 pressure treated wood balusters are installed spaced regularly every 3.5". Then ...

  3. Tied-arch bridge - Wikipedia

    en.wikipedia.org/wiki/Tied-arch_bridge

    Since the beams extend the width of the post-tensioned concrete deck, the tensing cable pairs remain visible. A close-up of the river pier shows that the structural dead load is tied per span: The larger arch span uses thicker tensing cables and the reflex segments are not suspended from, but supported by steel beams, essentially completing the ...

  4. Plate girder bridge - Wikipedia

    en.wikipedia.org/wiki/Plate_girder_bridge

    In the deck-type bridge, a wood, steel or reinforced concrete bridge deck is supported on top of two or more plate girders, and may act compositely with them. In the case of railroad bridges, the railroad ties themselves may form the bridge deck, or the deck may support ballast on which the track is laid.

  5. King post - Wikipedia

    en.wikipedia.org/wiki/King_post

    The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).

  6. Deck (building) - Wikipedia

    en.wikipedia.org/wiki/Deck_(building)

    Decks can also be covered by a canopy or pergola to control sunlight. Deck designs can be found in numerous books, do-it-yourself magazines, and websites, and from the USDA. [8] Typical construction is either of a post and beam architecture, or a cantilever construction. The post-and-beam construction relies on posts anchored to piers in the ...

  7. Girder bridge - Wikipedia

    en.wikipedia.org/wiki/Girder_bridge

    The deck includes any road lanes, medians, sidewalks, parapets or railings, and miscellaneous items like drainage and lighting. The supporting structure consists of the steel or concrete system supporting the deck. This includes the girders themselves, diaphragms or cross-braces, and (if applicable) the truss or arch system.

  8. Flitch beam - Wikipedia

    en.wikipedia.org/wiki/Flitch_beam

    A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts.

  9. Double tee - Wikipedia

    en.wikipedia.org/wiki/Double_tee

    Diagram of double tee beam. A double tee or double-T beam is a load-bearing structure that resembles two T-beams connected to each other side by side. The strong bond of the flange (horizontal section) and the two webs (vertical members, also known as stems) creates a structure that is capable of withstanding high loads while having a long span.

  1. Ads

    related to: post to deck connection detail design and layout