Search results
Results from the WOW.Com Content Network
An optical sensor can measure the changes from one or several light beams. When a change occurs, the light sensor operates as a photoelectric trigger and therefore either increases or decreases the electrical output. An optical switch enables signals in optical fibers or integrated optical circuits to be switched selectively between circuits ...
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
The slotted optical switch, sometimes known as opto switch or optical switch but not to be confused with the optical component, is a device comprising a photoemitter (e.g. LED) and a photodetector (e.g. photodiode) mounted in a single package so that the photoemitter normally illuminates the photodetector, but an opaque object can be inserted in a slot between them so as to break the beam.
A generator interlock kit (or a transfer switch), eliminates the need for extension cords to power appliances. [2]Like a transfer switch, an interlock kit lets the generator energize the panel and all of its circuits (up to the load capacity of the generator); not just corded appliances.
An important part of an optical power meter sensor, is the fiber optic connector interface. Careful optical design is required to avoid significant accuracy problems when used with the wide variety of fiber types and connectors typically encountered. Another important component, is the sensor input amplifier.
Hall sensors ICs often integrate digital electronics. [26] This enables advanced corrections to the sensor characteristics (e.g. temperature-coefficient corrections), digital communication to microprocessor systems, and may provide interfaces for input diagnostics, fault protection for transient conditions, and short/open-circuit detection.
An optical parametric amplifier, abbreviated OPA, is a laser light source that emits light of variable wavelengths by an optical parametric amplification process. It is essentially the same as an optical parametric oscillator , but without the optical cavity (i.e., the light beams pass through the apparatus just once or twice, rather than many ...
Zero speed switches (ZSS) also known as Speed Actuating Sensing Switches [1] are used to detect whether a rotating shaft is turning (even at very slow speeds) [2] in various machines, conveyors, power plants, and in industries involving the production of cement, sugar, textiles, paper, etc. Zero speed switches mainly use electromechanical, electronic, or magnetic proximity technologies.