Search results
Results from the WOW.Com Content Network
Regenerative receivers require fewer components than other types of receiver circuit, such as the TRF and superheterodyne. The circuit's advantage was that it got much more amplification (gain) out of the expensive vacuum tubes , thus reducing the number of tubes required and therefore the cost of a receiver.
Classical regenerative receiver using a single triode vacuum tube. The orientation of the "tickler" coil was carefully adjusted by the operator in order to vary the amount of positive feedback. The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the ...
It is a regenerative amplifier adjusted to provide positive feedback within the receiver. This has the effect of narrowing the receiver's bandwidth, as if the Q factor of its tuned circuits had been increased. The Q multiplier was a common accessory in shortwave receivers of the vacuum tube era as either a factory installation or an add-on ...
C1 is the gridleak capacitor. C2 is a radio frequency bypass capacitor. L4 is an inductance without inductive coupling to L. Together with the tube internal capacitor between anode and grid L4 creates a negative differential resistance at the grid. Regenerative control is as in Fig. 8. Fig. 10 AM band NPN audion receiver
References ^ "Why it is preferred to have local oscillator frequency larger than carrier frequency in superheterodyne receiver?". electronics.stackexchange.com. Retrieved 4 February 2019. Double tuned Superheterodyne receivers usually contain double tuned circuits (sets of two loosely coupled circuits) as filters in IF receiver - this is because such a filter has almost flat band instead a ...
The receiver sensitivity rises while the oscillation builds up. The oscillation stops when the operation point no longer fulfills the Barkhausen stability criterion. The blocking oscillator recovers to the initial state and the cycle starts again. [2] The receive frequency of the Armstrong Super-Regenerative receiver was some hundred kilohertz.
By the early 1930s National had established a reputation with the amateur radio community based upon their line of regenerative receivers, including the SW-3 and SW-5. National HRO receiver, circa 1938 Logo of National Company, late 1940s. In 1935 National introduced their top-of-the-line HRO receiver. This radio included two RF stages and a ...
3 TRF vs regenerative receiver. 6 comments. 4 Bad definition of TRF in How it works section. 2 comments. 5 Tuned radio frequency versus heterodyne, and WWII. 2 comments.