Search results
Results from the WOW.Com Content Network
Regenerative receivers require fewer components than other types of receiver circuit, such as the TRF and superheterodyne. The circuit's advantage was that it got much more amplification (gain) out of the expensive vacuum tubes , thus reducing the number of tubes required and therefore the cost of a receiver.
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
A 5-tube superheterodyne receiver manufactured by Toshiba circa 1955 Superheterodyne transistor radio circuit circa 1975. A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original carrier frequency.
A shortwave radio receiver is a radio receiver that can receive one or more shortwave bands, between 1.6 and 30 MHz. A shortwave radio receiver often receives other broadcast bands, such as FM radio, Longwave and Mediumwave. Shortwave radio receivers are often used by dedicated hobbyists called shortwave listeners.
References ^ "Why it is preferred to have local oscillator frequency larger than carrier frequency in superheterodyne receiver?". electronics.stackexchange.com. Retrieved 4 February 2019. Double tuned Superheterodyne receivers usually contain double tuned circuits (sets of two loosely coupled circuits) as filters in IF receiver - this is because such a filter has almost flat band instead a ...
Reaction sets, also known as regenerative receivers, rely on positive feedback to achieve adequate gain. This approach provided high performance with a minimum number of expensive vacuum tubes, but these receivers tended to radiate RF interference in their immediate vicinity.
C1 is the gridleak capacitor. C2 is a radio frequency bypass capacitor. L4 is an inductance without inductive coupling to L. Together with the tube internal capacitor between anode and grid L4 creates a negative differential resistance at the grid. Regenerative control is as in Fig. 8. Fig. 10 AM band NPN audion receiver
A direct-conversion receiver (DCR), also known as homodyne, synchrodyne, or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.