enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Volume fraction - Wikipedia

    en.wikipedia.org/wiki/Volume_fraction

    The volume of such a mixture is slightly less than the sum of the volumes of the components. Thus, by the above definition, the term "40% alcohol by volume" refers to a mixture of 40 volume units of ethanol with enough water to make a final volume of 100 units, rather than a mixture of 40 units of ethanol with 60 units of water.

  3. Dilution ratio - Wikipedia

    en.wikipedia.org/wiki/Dilution_ratio

    The following formulas can be used to calculate the volumes of solute (V solute) and solvent (V solvent) to be used: [1] = = where V total is the desired total volume, and F is the desired dilution factor number (the number in the position of F if expressed as "1/F dilution factor" or "xF dilution"). However, some solutions and mixtures take up ...

  4. Reduced properties - Wikipedia

    en.wikipedia.org/wiki/Reduced_properties

    In thermodynamics, the reduced properties of a fluid are a set of state variables scaled by the fluid's state properties at its critical point.These dimensionless thermodynamic coordinates, taken together with a substance's compressibility factor, provide the basis for the simplest form of the theorem of corresponding states.

  5. Partial molar property - Wikipedia

    en.wikipedia.org/wiki/Partial_molar_property

    When one mole of water is added to a large volume of water at 25 °C, the volume increases by 18 cm 3. The molar volume of pure water would thus be reported as 18 cm 3 mol −1. However, addition of one mole of water to a large volume of pure ethanol results in an increase in volume of only 14 cm 3. The reason that the increase is different is ...

  6. Mixing ratio - Wikipedia

    en.wikipedia.org/wiki/Mixing_Ratio

    In chemistry and physics, the dimensionless mixing ratio is the abundance of one component of a mixture relative to that of all other components. The term can refer either to mole ratio (see concentration ) or mass ratio (see stoichiometry ).

  7. Excess property - Wikipedia

    en.wikipedia.org/wiki/Excess_property

    The molar volume of a mixture can be found from the sum of the excess volumes of the components of a mixture: = (+ ¯). This formula holds because there is no change in volume upon mixing for an ideal mixture. The molar entropy, in contrast, is given by

  8. Molar volume - Wikipedia

    en.wikipedia.org/wiki/Molar_volume

    The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...

  9. Compressibility factor - Wikipedia

    en.wikipedia.org/wiki/Compressibility_factor

    Once two of the three reduced properties are found, the compressibility chart can be used. In a compressibility chart, reduced pressure is on the x-axis and Z is on the y-axis. When given the reduced pressure and temperature, find the given pressure on the x-axis. From there, move up on the chart until the given reduced temperature is found.