Search results
Results from the WOW.Com Content Network
Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...
A Y-cable common in domestic settings has a stereo 3.5mm (1/8″) stereo male minijack at one end, to plug into the line- or headphone-output of an MP3 player, mobile phone, or computer soundcard, and a pair of RCA (phono) male plugs to connect to the left and right mono inputs of an external amplifier.
A speaker system has to be wired to accommodate either configuration, typically with two sets of binding posts, one set for the bass and one set for the mid-highs. A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range.
Resistance is by far the most important specification of speaker wire. [4] Low-resistance speaker wire allows more of the amplifier's power to energize the loudspeaker's voice coil. The performance of a conductor such as speaker wire is therefore optimised by limiting its length and maximising its cross-sectional area.
While the above discussion focuses on preventing noise from getting in (e.g. into a microphone cable) the same star-quad quadrupole configuration is useful for audio speaker cable, [11] for split-phase electric power wiring, and even for open-wire star quad transmission line. In these cases, the purpose of the star quad configuration is reversed.
W-USB interacts with wired USB via wire adapters. W-USB can form true USB systems, formed by a host, devices and interconnection support. It implements the USB hub–spoke model, in which up to 127 wireless devices can form point-to-point links (spokes) with the host (the hub). The host controller is unique in the system and is usually embedded ...
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.