enow.com Web Search

  1. Ads

    related to: insulated solder terminals for wire mesh sheets 5mm

Search results

  1. Results from the WOW.Com Content Network
  2. FASTON terminal - Wikipedia

    en.wikipedia.org/wiki/FASTON_terminal

    The terminal system consists of tabs (male) and receptacles (female). There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). A hand tool exists for inserting the terminals: the AMP Universal Handle. [citation needed]

  3. Electric wire ferrule - Wikipedia

    en.wikipedia.org/wiki/Electric_wire_ferrule

    Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation may be ...

  4. IDC (electrical connector) - Wikipedia

    en.wikipedia.org/wiki/IDC_(electrical_connector)

    An insulation-displacement contact (IDC), also known as insulation-piercing contact (IPC), is an electrical connector designed to be connected to the conductor(s) of an insulated cable by a connection process which forces a selectively sharpened blade or blades through the insulation, bypassing the need to strip the conductors of insulation ...

  5. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available.

  6. 110 block - Wikipedia

    en.wikipedia.org/wiki/110_block

    A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

  7. Terminal (electronics) - Wikipedia

    en.wikipedia.org/wiki/Terminal_(electronics)

    Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.

  8. JST connector - Wikipedia

    en.wikipedia.org/wiki/JST_connector

    It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

  9. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    This is surrounded by a circular shroud on the male connector, which fits into a matching recess on the female connector. The standard defines connectors with 3, 4 and 5 pins, but a non-standard variant with 7 pins (6 in a circle plus one in the centre) is commercially available; [ 6 ] this can be used for star-delta starting of three-phase motors.

  1. Ads

    related to: insulated solder terminals for wire mesh sheets 5mm