Search results
Results from the WOW.Com Content Network
The Syracuse New Process Gear plant produced transfer cases for all of the "Big Three"—Ford, Chrysler, and General Motors. The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler ...
Offered as standard equipment for K-series trucks with inline-6 engines, [52] the conventional four-wheel drive system was equipped with a two-speed New Process 205 transfer case with four drive modes: Two High, Four High, Neutral, and Four Low. Two High gave a 0:100 torque split, while Four High yielded a locked 50:50 torque split.
Two transfer cases were offered: the Dana 20, available only with the manual transmissions, or the NP-205, available with both types of transmissions. The Blazer had 8 inches (200 mm) of ground clearance and an approach angle of 35°. [2] Engines. 250 cu in (4.1 L) High Torque I6 (1969–1984)
A divorced or independent transfer case is completely separate from the transmission. It is located further down the driveline than a married transfer case and connected to the transmission output shaft by a short driveshaft. Independent transfer cases are used on very long wheelbase vehicles, such as commercial trucks or military trucks.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
New Process transfer cases are chain-driven and use a circular 6 bolt, 23-spline input on the case. The output for the front drive shaft is on the left side. The New Process transfer cases used by AMC attach the same as the Dana 300 except that New Process cases have the front output on the left side.
Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.
The Synchro-mesh 465 or SM465 is a heavy-duty, four-speed manual transmission built by General Motors for use in light and medium duty trucks from 1968 to 1991 at the factory in Muncie, Indiana; it was designed to replace the somewhat similar Muncie SM420 transmission, which had been in production since just after World War II.