Search results
Results from the WOW.Com Content Network
When the furnace works properly, it shouldn't smell or make much noise. If you detect a musty or burning smell coming from the furnace, it could indicate a more serious issue that requires the ...
The original Berger lamp used methyl alcohol, while modern lamps use isopropyl alcohol (90% or more). [5] Perfumes or essential oils may be added. To start the catalytic process it is necessary to allow the wick to thoroughly absorb the fuel and then to light the catalytic burner with a flame and let it burn for approximately two minutes until the catalytic stone reaches the correct operating ...
Phantosmia (phantom smell), also called an olfactory hallucination or a phantom odor, [1] is smelling an odor that is not actually there. This is intrinsically suspicious as the formal evaluation and detection of relatively low levels of odour particles is itself a very tricky task in air epistemology.
This lamp was the most important article of furniture for the Inuit, Yupik and other Inuit peoples. [9] The lamps were made of stone and their sizes and shapes of lamps could be different, but mostly were elliptical or half-moon shaped. The wicks were mostly made of dried moss or cottongrass and were lit along the edge of the lamp. A slab of ...
A carbide lamp or acetylene gas lamp is a simple lamp that produces and burns acetylene (C 2 H 2), which is created by the reaction of calcium carbide (CaC 2) with water (H 2 O). [ 1 ] Acetylene gas lamps were used to illuminate buildings, as lighthouse beacons, and as headlights on motor-cars and bicycles.
Burning fluid could be used in a simple small table and hand lamps, requiring no chimney. [22] Burning fluid lamps had two long tapering wick tubes that looked like the letter V. The tubes had caps resembling thimbles to extinguish the light and prevent evaporation when the lamp was not in use. Camphine lamps had a single fixed wick with a ...
You can thank the wind for the odor.
A 50-hour-life projection bulb, for instance, is designed to operate only 50 °C (122 °F) below that melting point. Such a lamp may achieve up to 22 lumens per watt, compared with 17.5 for a 750-hour general service lamp. [76] Lamps of the same power rating but designed for different voltages have different luminous efficacy.