Ad
related to: low speed shaft generator parts model 66619 diagramtemu.com has been visited by 1M+ users in the past month
- Store Locator
Team up, price down
Highly rated, low price
- Sale Zone
Special for you
Daily must-haves
- Temu-You'll Love
Enjoy Wholesale Prices
Find Everything You Need
- Best Seller
Countless Choices For Low Prices
Up To 90% Off For Everything
- Store Locator
Search results
Results from the WOW.Com Content Network
A permanent magnet synchronous generator is a generator where the excitation field is provided by a permanent magnet instead of a coil. The term synchronous refers here to the fact that the rotor and magnetic field rotate with the same speed, because the magnetic field is generated through a shaft-mounted permanent magnet mechanism, and current is induced into the stationary armature.
The rotor operates at synchronous speeds without current-conducting parts. Rotor losses are minimal compared to those of an induction motor, however it normally has less torque. [2] [3] Once started at synchronous speed, the motor can operate with sinusoidal voltage. Speed control requires a variable-frequency drive.
Since it has a low price, and good regulation, cross-flow turbines are mostly used in mini and micro hydropower units of less than one thousand kW and with heads less than 200 m (660 ft). Particularly with small run-of-the-river plants , the flat efficiency curve yields better annual performance than other turbine systems, as small rivers ...
By adjusting the shape of the bars in the rotor, the speed-torque characteristics of the motor can be changed, to minimize starting current or to maximize low-speed torque, for example. Squirrel-cage induction motors are very prevalent in industry, in sizes from below 1 kilowatt (1.3 hp) up to tens of megawatts (tens-of-thousand horsepower).
The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.
Formally, it is an electric transmission device that allows energy flow between two electrical rotating parts, such as in a motor. Slip rings on a hydroelectric generator; A - stationary spring-loaded graphite brushes, B - rotating steel contact ring, C - insulated connections to generator field winding, D - top end of generator shaft.
This small shaft deflection, only detectable by eccentricity meters, would be enough to cause damaging vibrations to the entire steam turbine generator unit when it is restarted. The shaft is therefore automatically turned at low speed (about one percent rated speed) by the barring gear until it has cooled sufficiently to permit a complete stop.
Campbell Diagram of a steam turbine. Analysis shows that there are well-damped critical speed at lower speed range. Another critical speed at mode 4 is observed at 7810 rpm (130 Hz) in dangerous vicinity of nominal shaft speed, but it has 30% damping - enough to safely ignore it.
Ad
related to: low speed shaft generator parts model 66619 diagramtemu.com has been visited by 1M+ users in the past month