enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Accessory drive - Wikipedia

   en.wikipedia.org/wiki/Accessory_drive

   Klimov TV3-117 turboshaft engine. The accessory drive is the large casting on the top. The accessory drive is a gearbox that forms part of a gas turbine engine. [1] Although not part of the engine's core, it drives the accessories – such as generators, pumps for fuel and lubrication oil, air compressors, hydraulic pumps and engine starters – that are otherwise essential for the operation ...

3. Kaplan turbine - Wikipedia

   en.wikipedia.org/wiki/Kaplan_turbine

   S-turbines eliminate the need for a bulb housing by placing the generator outside of the water channel. This is accomplished with a jog in the water channel and a shaft connecting the runner and generator. The VLH turbine is an open flow, very low head "kaplan" turbine slanted at an angle to the water flow. It has a large diameter >3.55 m, is ...

4. Hydrogen-cooled turbo generator - Wikipedia

   en.wikipedia.org/.../Hydrogen-cooled_turbo_generator

   The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.

5. Turbo generator - Wikipedia

   en.wikipedia.org/wiki/Turbo_generator

   The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.

6. Microturbine - Wikipedia

   en.wikipedia.org/wiki/Microturbine

   They comprise a compressor, combustor, impeller/turbine and electric generator on a single shaft or two. They can have a recuperator capturing waste heat to improve the compressor efficiency, an intercooler and reheat. They rotate at over 40,000 RPM and a common single shaft microturbine rotate usually at 90,000 to 120,000 RPM. [2]

7. Free-turbine turboshaft - Wikipedia

   en.wikipedia.org/wiki/Free-turbine_turboshaft

   This refers to the number of compressor-and-turbine assemblies in the gas generator stage and does not include the free power turbine assembly. [2] As an example, the General Electric T64 is a single-spool design that uses a 14-stage axial compressor; the independent power shaft is coaxial with the gas generator shaft. [3]