Search results
Results from the WOW.Com Content Network
An onboard refueling vapor recovery system (ORVR) is a vehicle fuel vapor emission control system that captures volatile organic compounds (VOC, potentially harmful vapors) during refueling. [ 1 ] [ page needed ] There are two types of vehicle fuel vapor emission control systems: the ORVR, and the Stage II vapor recovery system. [ 2 ]
Vehicle emissions control is the study of reducing the emissions produced by motor vehicles, especially internal combustion engines.The primary emissions studied include hydrocarbons, volatile organic compounds, carbon monoxide, carbon dioxide, nitrogen oxides, particulate matter, and sulfur oxides.
The crankcase air outlet, where the PCV valve is located, is generally placed as far as possible from the crankcase breather. For example, the breather and outlet are frequently on opposite valve covers on a V engine, or on opposite ends of the valve cover on an inline engine. The PCV valve is often, but not always, placed at the valve cover ...
If the throttling valve or device is located at the entry into a pressure vessel so that the flash evaporation occurs within the vessel, then the vessel is often referred to as a flash drum. [1] [2] If the saturated liquid is a single-component liquid (for example, propane or liquid ammonia), a part
The vapor phase enters in the bottom of the column and exits out of the top. Inside of the column are trays or plates. These trays force the liquid to flow back and forth horizontally while the vapor bubbles up through holes in the trays. The purpose of these trays is to increase the amount of contact area between the liquid and vapor phases.
Flash gas is readily leaked whenever these hatches are opened and therefore they can pose a problem in terms of emissions. There have also been reports of fatalities caused by manual tank gauging and sampling via thief hatches. [63] Vapor recovery towers (VRT) have been posed as a potential solution for vapor loss via thief hatches.
Safety relief valves A spring-loaded safety relief valve is usually installed on all oil and gas separators. These valves normally are set at the design pressure of the vessel. Safety relief valves serve primarily as a warning, and in most instances are too small to handle the full rated fluid capacity of the separator. Full-capacity safety ...
Regeneration of a cryopump is the process of evaporating the trapped gases. During a regeneration cycle, the cryopump is warmed to room temperature or higher, allowing trapped gases to change from a solid state to a gaseous state and thereby be released from the cryopump through a pressure relief valve into the atmosphere.