Search results
Results from the WOW.Com Content Network
However, once water boils, it is an insulator, leading to a sudden loss of cooling where steam bubbles form. Steam may return to water as it mixes with other coolant, so an engine temperature gauge can indicate an acceptable temperature even though local temperatures are high enough that damage is being done. An engine needs different temperatures.
a thermostat to control temperature by varying the amount of coolant going to the radiator; a fan to draw cool air through the radiator. The combustion process produces a large amount of heat. If heat were allowed to increase unchecked, detonation would occur, and components outside the engine would fail due to excessive temperature. To combat ...
The temperature of the air entering the vehicle's interior can be controlled by using a valve limiting the amount of coolant that goes through the heater core. Another method is blocking off the heater core with a door, directing part (or all) of the incoming air around the heater core completely, so it does not get heated (or re-heated if the ...
Cooling is required to remove excessive heat—high temperature can cause engine failure, usually from wear (due to high-temperature-induced failure of lubrication), cracking or warping. Two most common forms of engine cooling are air-cooled and water-cooled. Most modern automotive engines are both water and air-cooled, as the water/liquid ...
Inspect the car's most difficult-to-clean places, such as under the seats, gaps in panels in the trunk and behind the engine, looking for mud, debris or water lines.
On the other hand, if the engine coolant gets too hot, it might boil while inside the engine, causing voids (pockets of steam), leading to localized hot spots and the catastrophic failure of the engine. If plain water were to be used as an engine coolant in northern climates freezing would occur, causing significant internal engine damage.
Device to measure the temperature to which the coolant protects the car from freezing. Water is the most common coolant. Its high heat capacity and low cost make it a suitable heat-transfer medium. It is usually used with additives, like corrosion inhibitors and antifreeze.
Superheated steam was widely used in main line steam locomotives. Saturated steam has three main disadvantages in a steam engine: it contains small droplets of water which have to be periodically drained from the cylinders; being precisely at the boiling point of water for the boiler pressure in use, it inevitably condenses to some extent in the steam pipes and cylinders outside the boiler ...