Search results
Results from the WOW.Com Content Network
The Duriron Company is an industrial component manufacturer of such products as automatic control valves, valves and actuators, pumps, sealing systems, filtration equipment, pipes and fittings. The company was incorporated in 1912 as the Duriron Casting Company in Dayton, Ohio by John R. Pitman, William E. Hall, and Pierce D. Schenck. [1]
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [1]
Gate valve, mainly for on–off control, with low pressure drop; Globe valve, good for regulating flow. Uses a cylinder movement over a seat; Knife valve, similar to a gate valve, but usually more compact. Often used for slurries or powders on–off control; Needle valve for accurate flow control; Pinch valve, for slurry flow regulation and ...
A Minnesota couple has reportedly been sentenced to four years after they locked their children in cages for "their safety." Benjamin and Christina Cotton from Red Wing, were sentenced by a ...
2000 - Ingersoll-Dresser Pumps (IDP) 2000 - Innovative Valve Technologies Inc. (Houston-based maintenance, repair, and replacement services for industrial valves, piping systems, and process system components [13]) 2002 - Flow Control division of Invensys (manufacturer of valves, actuators and associated flow control products [14])
President-elect Donald Trump suggested that Robert F. Kennedy Jr., his pick to run Health and Human Services, will investigate supposed links between autism and childhood vaccines, a discredited ...
Getting older has a few perks — wisdom, greater perspective on life and senior discounts among them — but most of us associate aging with the harsh reality of wrinkles, joint problems and a ...
A servo valve receives pressurized hydraulic fluid from a source, typically a hydraulic pump. It then transfers the fluid to a hydraulic cylinder in a closely controlled manner. Typically, the valve will move the spool proportionnaly to an electrical signal that it receives, indirectly controlling flow rate.