enow.com Web Search

  1. Ads

    related to: 2x4 exterior wall insulation

Search results

  1. Results from the WOW.Com Content Network
  2. External wall insulation - Wikipedia

    en.wikipedia.org/wiki/External_wall_insulation

    An external wall insulation system (or EWIS) is a thermally insulated, protective, and decorative exterior cladding procedure involving the use of expanded polystyrene, mineral wool, polyurethane foam or phenolic foam, topped off with a reinforced cement based, mineral or synthetic finish and plaster.

  3. Sound transmission class - Wikipedia

    en.wikipedia.org/wiki/Sound_transmission_class

    Installing absorptive insulation, for example fiberglass batts and blow-in cellulose, into the wall or ceiling cavities does increase the sound transmission class significantly. [14] The presence of insulation in single 2x4 wood stud framing spaced 16 inches (410 mm) on-center results in only a few STC points.

  4. Exterior insulation finishing system - Wikipedia

    en.wikipedia.org/wiki/Exterior_insulation...

    Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.

  5. Rigid panel - Wikipedia

    en.wikipedia.org/wiki/Rigid_panel

    A multi-family residential building under construction with rigid panel exterior insulating sheathing. Rigid panel insulation, also referred to as continuous insulation, [1] can be made from foam plastics such as polyurethane (PUR), polyisocyanurate (PIR), and polystyrene, or from fibrous materials such as fiberglass, rock and slag wool.

  6. Cladding (construction) - Wikipedia

    en.wikipedia.org/wiki/Cladding_(construction)

    Cladding in construction is material applied over another to provide a skin or layer and used to provide a degree of thermal insulation and weather resistance, and to improve the appearance of buildings. Between the cladding and the wall there is a cavity where rain can run down.

  7. Structural insulated panel - Wikipedia

    en.wikipedia.org/wiki/Structural_insulated_panel

    The third component in SIPs is the spline or connector piece between SIPs. Dimensional lumber is commonly used but creates thermal bridging and lowers insulation values. To maintain higher insulation values through the spline, manufacturers use Insulated Lumber, Composite Splines, Mechanical Locks, Overlapping OSB Panels, or other creative methods.

  1. Ads

    related to: 2x4 exterior wall insulation