enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Scan tool - Wikipedia

   en.wikipedia.org/wiki/Scan_tool

   An automotive scan tool (scanner) is an electronic tool used to interface with, diagnose and, sometimes, reprogram vehicle control modules. [1] There are many types from just as many manufacturers, one of the most familiar being the Snap-On Inc. "brick", or MT2500/MTG2500. Snap-On, Hella Gutmann Solutions, OTC/SPX, Xtool india, Autel, Launch ...

3. INCA (software) - Wikipedia

   en.wikipedia.org/wiki/INCA_(Software)

   A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.

4. On-board diagnostics - Wikipedia

   en.wikipedia.org/wiki/On-board_diagnostics

   A range of rugged hand-held scan tools is available. Simple fault code readers/reset tools are mostly aimed at the consumer level. Professional hand-held scan tools may possess more advanced functions Access more advanced diagnostics; Set manufacturer- or vehicle-specific ECU parameters; Access and control other control units, such as air bag ...

5. OBD-II PIDs - Wikipedia

   en.wikipedia.org/wiki/OBD-II_PIDs

   OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections. Manufacturers also ...

6. Data link connector - Wikipedia

   en.wikipedia.org/wiki/Data_link_connector

   The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...

7. Passthrough device - Wikipedia

   en.wikipedia.org/wiki/Passthrough_device

   A passthrough device is a device used in conjunction with a computer to reprogram vehicle control modules through the OBD-II/CANbus port. [1] Each manufacturer has their own type, but SAE International standardized the J-2534 universal requirements in 2004, requiring all manufacturers to allow vehicles sold in the United States of America and Europe to accept powertrain reprogramming through ...