Search results
Results from the WOW.Com Content Network
Classless Inter-Domain Routing (CIDR / ˈ s aɪ d ər, ˈ s ɪ-/) is a method for allocating IP addresses for IP routing.The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous classful network addressing architecture on the Internet.
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example:
Special address blocks Address block Address range Number of addresses Scope Description 0.0.0.0/8 0.0.0.0–0.255.255.255 16 777 216: Software Current (local, "this") network [1]
IPv6 multicast: [41] The low 32 bits an Ethernet address for IPv6 multicast traffic are the low 32 bits of the multicast IPv6 address used. [ 40 ] : §2.3.1 For example, IPv6 multicast traffic using the address ff02::d uses the MAC address 33-33-00-00-00-0D , and traffic to ff05::1:3 goes to the MAC address 33-33-00-01-00-03 .
In IPv6 this is the only standards-based form to denote network or routing prefixes. For example, the IPv4 network 192.0.2.0 with the subnet mask 255.255.255.0 is written as 192.0.2.0 / 24 , and the IPv6 notation 2001:db8:: / 32 designates the address 2001:db8:: and its network prefix consisting of the most significant 32 bits.
A /28 route, with a subnet mask of 255.255.255.240, is more specific than a /24 route, with a subnet mask of 255.255.255.0. If the route is of equal specificity to a route already in the routing table, but comes from a more preferred source of routing information, replace the route in the table.
IP addresses in dot-decimal notation are also presented in CIDR notation, in which the IP address is suffixed with a slash and a number, used to specify the length of the associated routing prefix. For example, 127.0.0.1/8 specifies that the IP address has an eight-bit routing prefix, and therefore the subnet mask 255.0.0.0 .
Cases where this setup is used can be found in servers dedicated for prints, files or for segmenting different departments. An example of router on a stick usage is found in Call Manager Express installation, when the Voice over IP network and Cisco IP phone devices have a need to split. [3]