enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Chipseal - Wikipedia

   en.wikipedia.org/wiki/Chipseal

   Chip seal products can be installed over gravel roads to eliminate the cost of grading, road roughness, dust, mud, and the cost of adding gravel lost from grading. Adding chip seal over gravel is about 25% of the price of resurfacing with asphalt, $170,000 for a 4-mile project done in Minnesota [6] compared to $760,000 had it been redone with ...

3. Stone mastic asphalt - Wikipedia

   en.wikipedia.org/wiki/Stone_mastic_asphalt

   The stone skeleton is filled with a mastic of bitumen and filler to which fibres are added to provide adequate stability of bitumen and to prevent drainage of binder during transport and placement. Typical SMA composition consists of 70−80% coarse aggregate, 8−12% filler, 6.0−7.0% binder, and 0.3 per cent fibre.

4. Otta seal - Wikipedia

   en.wikipedia.org/wiki/Otta_seal

   Otta seal is formed by adding graded aggregate to a soft bituminous binding agent. The agent is usually emulsified asphalt.Bituminous binder application rates are between 1.9 liter/m 2 (0.42 US gallon/yard 2) and 2.4 liter/m 2 (0.53 US gallon/yard 2) – the value is dependent on aggregate gradation and type.

5. Sealcoat - Wikipedia

   en.wikipedia.org/wiki/Sealcoat

   The process is typically a two-coat application which requires 24 to 48 hours of curing before vehicles can be allowed back on the surface. Once the surface is properly prepared, then properly mixed sealer will be applied at about 1.5 square meters per liter (60 sq ft per U.S. gal; 72 sq ft per Imp gal) per coat.

6. Wearing course - Wikipedia

   en.wikipedia.org/wiki/Wearing_course

   In flexible pavements, the upper layer consists of asphalt concrete, that is a construction aggregate with a bituminous binder. The wearing course is typically placed on the binder course which is then laid on the base course, which is normally placed on the subbase, which rests on the subgrade. There are various different types of flexible ...

7. Road surface - Wikipedia

   en.wikipedia.org/wiki/Road_surface

   Cold mix asphalt is often used on lower-volume rural roads, where hot mix asphalt would cool too much on the long trip from the asphalt plant to the construction site. [18] An asphalt concrete surface will generally be constructed for high-volume primary highways having an average annual daily traffic load greater than 1,200 vehicles per day. [19]