Search results
Results from the WOW.Com Content Network
If a hydraulic rotary pump with the displacement 10 cc/rev is connected to a hydraulic rotary motor with 100 cc/rev, the shaft torque required to drive the pump is one-tenth of the torque then available at the motor shaft, but the shaft speed (rev/min) for the motor is also only one-tenth of the pump shaft speed.
The stall speed is defined as the highest speed at which the pump can turn when the output turbine is locked and full input torque (at the stall speed) is applied. Under stall conditions all of the engine's power at that speed would be dissipated in the fluid coupling as heat, possibly leading to damage.
Hydraulic hybrid vehicle systems consists of four main components: the working fluid, reservoir, pump/motor (in parallel hybrid system) or in-wheel motors and pumps (in series hybrid system), and accumulator. In some systems, a hydraulic transformer is also installed for converting output flow at any pressure with a very low power loss. [3]
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Originally, this fluid was water; today, the wider use is in hydraulic devices. Myron F. Hill, who might be called the father of the gerotor, in his booklet "Kinematics of Ge-rotors", lists efforts by Galloway in 1787, by Nash and Tilden in 1879, by Cooley in 1900, by Professor Lilly of Dublin University in 1915, and by Feuerheerd in 1918.
On Nov. 28, deputies responded the couple's home, charging documents show, after receiving a call from a Department of Families Services employee contacted by a hospital employee about a child ...
Another way of changing speed of a direct current motor is to change the voltage applied to the armature. An adjustable-speed motor drive might consist of an electric motor and controller that is used to adjust the motor's operating speed. The combination of a constant-speed motor and a continuously adjustable mechanical speed-changing device ...
The speed and force of an actuator depend on its gearbox. The amount of force depends on the actuator’s speed. Lower speeds supply greater force because motor speed and force are constant. One of the basic differences between actuators is their stroke, which is defined by the length of the screw and shaft.