Search results
Results from the WOW.Com Content Network
The modern toilet utilises a cistern to reserve and hold the correct amount of water required to flush the toilet bowl. In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the ...
The prepontine cistern, or pontine cistern is one of the subarachnoid cisterns situated ventral to the pons. [1] It contains the basilar artery . [ 2 ] : 478 Each lateral aperture opens into the pontine cistern just posterior to the cranial nerve VIII .
It consists of a valve connected to a hollow, sealed float by means of a lever mounted near the top of the tank. The float is often ball-shaped, hence the name ballcock . The valve is connected to the incoming water supply , and is opened and closed by the lever which has the float mounted on the end.
There are also dual-flush toilets that use a siphon valve operated by a lever rather than buttons, with a ≤ 6L full flush, and a ≤ 3L half-flush if the flush handle is held down [8] or released immediately after flushing. [9] Tipping bucket. The tipping bucket cistern can operate in a dual flush mode when the lever is rotated halfway 2.5/5 ...
Choke valve, Butterfly valve used to limit air intake in internal combustion engine. (Not to be confused with choke valves used in industrial flow control, above.) Clapper valve: a type of check valve used in the Siamese fire appliance to allow only one hose to be connected instead of two (the clapper valve blocks the other side from leaking out)
In April 1831, a new water supply and distribution system opened, for fighting fires. It included a well and cistern on 13th Street between Bowery (today 4th Avenue) and Third Avenue, which was then at the northern fringes of the city.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
A back-pressure regulator, back-pressure valve, pressure sustaining valve or pressure sustaining regulator is a control valve that maintains the set pressure at its inlet side by opening to allow flow when the inlet pressure exceeds the set value.