Ads
related to: how much jitter is acceptable for voip internetassistantmagic.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The term PDV is defined in ITU-T Recommendation Y.1540, Internet protocol data communication service - IP packet transfer and availability performance parameters, section 6.2. In computer networking, although not in electronics, usage of the term jitter may cause confusion. From RFC 3393 (section 1.1):
The RTCP extended report VoIP metrics block specified by RFC 3611 is generated by an VoIP phone or gateway during a live call and contains information on packet loss rate, packet discard rate (because of jitter), packet loss/discard burst metrics (burst length/density, gap length/density), network delay, end system delay, signal/noise/echo ...
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
G.114 is an ITU Recommendation that addresses acceptable delays for voice applications, is oriented to national telecommunications, and is more stringent than what is normally applied in private voice networks. One of the issues it addresses is voice delay. It states that 150 milliseconds is acceptable, while 400 milliseconds is unacceptable ...
Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...
Destinations are required to use a buffer of 3 times the packet time, though at least 20 times the packet time (or 20 ms if smaller) is recommended. Sources are required to maintain transmission with jitter of less than 17 packet times (or 17 ms if shorter), though 1 packet time (or 1 ms if shorter) is recommended.
Ads
related to: how much jitter is acceptable for voip internetassistantmagic.com has been visited by 10K+ users in the past month