Search results
Results from the WOW.Com Content Network
In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe. Drill string (#25) is an assembled collection of drill pipe, heavy weight drill pipe, drill collars and any of a whole assortment of tools, connected and run into the ...
The drill string consists of both drill pipe and the bottom hole assembly (BHA), which is the tubular portion closest to the bit. The BHA will be made of thicker walled heavy weight drill pipe (HWDP) and drill collars, which have a larger outside diameter and provide weight to the drill bit and stiffness to the drilling assembly.
In this instance the drill collars provide the necessary weight on the bit. Type 2 uses heavy weight drill pipe as a transition between the drill collars and the drill pipe. Weight on bit is achieved by the drill collars. Type 3 uses the drill collars to achieve directional control. The heavy weight drill pipe applies the weight on the bit.
BPV – back pressure valve (goes on the end of coiled tubing a drill pipe tool strings to prevent fluid flow in the wrong direction) BQL – B/QL log; BRPLG – bridge plug log; BRT – below rotary table (used as a datum for depths in a well) BS – bend stiffener; BS – bumper sub; BS – booster station
Drill pipe makes up the majority of the drill string back up to the surface. Each drill pipe comprises a long tubular section with a specified outside diameter (e.g. 3 1/2 inch, 4 inch, 5 inch, 5 1/2 inch, 5 7/8 inch, 6 5/8 inch). At each end of the drill pipe, tubular larger-diameter portions called the tool joints are located.
A typical piece of casing might be described as 9-5/8" 53.5# P-110 LT&C Rg 3: specifying OD, weight per foot (53.5 lbm/ft thus 0.545-inch wall thickness and 8.535-inch inside diameter), steel strength (110,000 psi yield strength), end finish ("Long Threaded and Coupled"), and approximate length ("Range 3" usually runs between 40 and 42 feet).
After declining by over 18% in 2022, the S&P 500 has been on a roll for the past two years. In 2023, the U.S. stock market's most important index gained over 24%, and so far in 2024 it has gained ...
Drilling mud must suspend drill cuttings and weight materials under a wide range of conditions. Drill cuttings that settle can cause bridges and fill, which can cause stuck pipe and lost circulation. Heavy material that settles is referred to as sag, which causes a wide variation in the density of well fluid.