Search results
Results from the WOW.Com Content Network
For this reason turboprop engines are not commonly used on aircraft [4] [5] [6] that fly faster than 0.6–0.7 Mach, [7] with some exceptions such as the Tupolev Tu-95. However, propfan engines, which are very similar to turboprop engines, can cruise at flight speeds approaching 0.75 Mach. To maintain propeller efficiency across a wide range of ...
Some large turboprop engines, such as the original Bristol Proteus and the modern TP400 have free turbines. The TP400 is a three-shaft design, with two compressor turbines and a separate power turbine. Where the turbine is at the rear of the engine, a turboprop engine requires a long drive shaft forwards to the propeller reduction gearbox. Such ...
For instance, in aircraft, turbine (jet and turboprop) engines are typically much smaller and lighter than equivalently powerful piston engine designs, both properties reducing the levels of drag on the plane and reducing the amount of power needed to move the aircraft. Therefore, turbines are more efficient for aircraft propulsion than might ...
A turboshaft engine is a form of gas turbine that is optimized to produce shaft horsepower rather than jet thrust. In concept, turboshaft engines are very similar to turbojets, with additional turbine expansion to extract heat energy from the exhaust and convert it into output shaft power. They are even more similar to turboprops, with only ...
Jet airliners have become 70% more fuel efficient between 1967 and 2007. [30] Jetliner fuel efficiency improves continuously, 40% of the improvement come from engines and 30% from airframes. [31] Efficiency gains were larger early in the jet age than later, with a 55–67% gain from 1960 to 1980 and a 20–26% gain from 1980 to 2000. [32]
The type of jet engine used to explain the conversion of fuel into thrust is the ramjet.It is simpler than the turbojet which is, in turn, simpler than the turbofan.It is valid to use the ramjet example because the ramjet, turbojet and turbofan core all use the same principle to produce thrust which is to accelerate the air passing through them.
The turbojet powered Heinkel He 178, the world's first jet aircraft, makes its first flight. 1940: Jendrassik Cs-1, a turboprop engine, made its first bench run. The Cs-1 was designed by Hungarian engineer György Jendrassik, and was intended to power a Hungarian twin-engine heavy fighter, the RMI-1. Work on the Cs-1 stopped in 1941 without the ...
The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.