Search results
Results from the WOW.Com Content Network
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
For the wide-ratio transmission, the first gear ratio is 4:1 or 4, and in second gear it is 2:1 or 2, so the progression is equal to 4 / 2 = 2 (or 200%). For the close-ratio transmission, first gear has a 4:1 ratio or 4, and second gear has a ratio of 3:1 or 3, so the progression between gears is 4 / 3 , or 133%. Since 133% is ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
A continuously variable transmission (CVT) can change seamlessly through a continuous (infinite) range of gear ratios, compared with other automatic transmissions that provide a limited number of gear ratios in fixed steps. The flexibility of a CVT with suitable control may allow the engine to operate at a constant angular velocity while the ...
The transmission's outer clutch K2 engages at the start of the bite point, while on the alternate gear shaft the reverse gear clutch K1 is also selected. [2] [3] The clutch pack for second gear (K2) gets ready to engage. When the driver releases the brake pedal, the K2 clutch clamping force is increased, allowing the transmission to drive the ...
A dog-leg gearbox or dogleg gearbox is a manual transmission shift pattern distinguished by an up-over-up shift between first and second gear. [1] The layout derives its name from a dog's hind leg, with its sharp angles. Dog leg gearboxes were replaced in most mass production vehicles by transmissions with a standard gear layout.
By selecting L from stationary, or before an upward gear change into 2nd gear, the transmission will become locked in 1st gear. By selecting L from D2 or D1 while in 2nd gear, the transmission will become locked in 2nd gear or from D2 or D1 when cruising below 55 m.p.h (88 k.p.h.) will effect an immediate downward change and lock in 2nd gear.