Search results
Results from the WOW.Com Content Network
MCU 8051 IDE is a free software integrated development environment for microcontrollers based on the 8051.MCU 8051 IDE has a built-in simulator not only for the MCU itself, but also LCD displays and simple LED outputs as well as button inputs.
A combination of an ATmega328P and an I²C based RGB backlit LCD interface (software compatible with the Adafruit RGB LCD shield), along with a USB serial programming interface done as a "backpack" module for the LCD. LEDuino [185] A board with enhanced I²C, DCC decoder and CAN-bus interfaces. Manufactured using surface mount and sold ...
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
The AVR Butterfly demonstrates LCD driving by running a 14-segment, six alpha-numeric character display. However, the LCD interface consumes many of the I/O pins. The Butterfly's ATmega169 CPU is capable of speeds up to 8 MHz, but it is factory set by software to 2 MHz to preserve the button battery life.
In AmigaOS one can use the i2c.resource component [25] for AmigaOS 4.x and MorphOS 3.x or the shared library i2c.library by Wilhelm Noeker for older systems. Arduino developers can use the "Wire" library. CircuitPython and MicroPython developers can use the busio.I2C or machine.I2C classes respectively.
The Arduino Nano is an open-source breadboard-friendly microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2008. It offers the same connectivity and specs of the Arduino Uno board in a smaller form factor.
A general-purpose input/output (GPIO) is an uncommitted digital signal pin on an integrated circuit or electronic circuit (e.g. MCUs/MPUs) board which may be used as an input or output, or both, and is controllable by software. GPIOs have no predefined purpose and are unused by default.
setup(): a function run once at the start of a program which can be used to define initial environment settings. loop(): a function called repeatedly until the board is powered off or reset. A typical first program for a developer using a microcontroller is to blink a light-emitting diode (LED) on and off. In the Wiring environment, the user ...